Execute an EOA step

EOA steps execute directly from one connected wallet. There is no multisig review after you confirm the wallet prompt.

Before you begin

• The run is published and the step is ready.
• You control the expected EOA as a personal wallet.
• The wallet is connected to the expected chain.

Execute

1. Open the ready step and select the wallet execution action.
2. Confirm the connected account and chain.
3. Compare the wallet request with txcast’s target, value, and calldata.
4. Sign and broadcast transaction index 0.
5. Wait for txcast to record and verify its hash.
6. Continue with each later transaction in the displayed order.

The step completes only after every transaction is verified with the network’s configured confirmation depth. Dependencies remain blocked until then.

Caution

EOA batches are not atomic. If an earlier transaction succeeds and a later one fails, do not resend the earlier transaction. Investigate the failed index and the resulting onchain state.

Wrong chain or account

Reject the wallet prompt, switch the wallet to the account and chain shown by txcast, then prepare again. Never modify the destination or calldata inside a wallet advanced-settings screen.

Pending receipt

A submitted hash may remain pending while the transaction is unmined or below the configured confirmation depth. Use Sync after the chain has progressed. See wallet troubleshooting.